New System Provides Power, Water, Refrigeration from One Source
When hurricanes, wars or other emergencies force authorities to respond, three essentials top their list of must-haves: water, electricity and refrigeration. Now, in a project funded by the U.S. Army, two University of Florida engineers have designed, built and successfully tested a combined power-refrigeration system that
can provide all three — and, with further development, be made compact enough to fit inside a military jet or large truck. “If you’re in a forward base in Iraq, it costs you the same per gallon of water as it does per gallon of fuel,” said William Lear, a UF associate professor of mechanical and aerospace engineering. “It would be better to just have to send fuel out there, especially if you could get refrigeration and water out of it — which is what our system achieves.” Lear and UF mechanical engineering professor S.A. Sherif have published several academic papers on various aspects of the system, which is being patented by UF. In November, they will present a paper discussing the system’s experimental results at the International Mechanical Engineering Congress & Exposition in Chicago. Both the Federal Emergency Management Agency and the military now rely on large generators to produce electricity in hazard zones. For cooling, they either haul in ice or electricity-hogging refrigerators. Depending on the location and emergency, imported fresh water may be another major logistical challenge and expense. Hoping to cut costs and simplify the process, the Army has provided a $750,000 grant to a small Gainesville company funding Lear and Sherif’s research on an alternative. The engineering researchers’ solution: a small system that ties a novel gas turbine power plant to a heat-operated refrigeration system. The refrigeration makes the gas turbine more efficient, while also producing cool air and potable water. The turbine can run on conventional fossil fuels as well as biomass-produced fuels or hydrogen. Lear said gas turbines are a common power generator used in everything from jet engines to electricity plants. The problem with traditional versions is that they lose efficiency both when not operated at full power and in warm temperatures, he said. Seeking to erase this loss, he rerouted the path of gases passing through the turbine, cooling them via heat exchangers. Sherif, an expert in refrigeration, then tied the system to absorption units, cooling the gases still more. Users can either tap all the cooling power to obtain peak efficiency for the turbine, or divert some for refrigeration or air conditioning. “You can decide how much of one you want versus how much of the other, depending on your needs,” Sherif said. Lear said his experiments and computer models suggest that with all the cooling devoted to the turbine, it will be 5 to 8 percent more efficient than traditional turbines. With some cooling siphoned for other purposes, it was still 3 to 5 percent more efficient than the turbines. Contrasting traditional gas turbines, the system maintains its efficiency whether operated at peak or partial power. A few percentage points might not seem like much, but it makes a big difference when fuel is scarce or expensive, particularly if refrigeration and water are added bonuses, Lear said. “Power companies would kill for a 1 percent gain,” he said. The system, which makes water by condensing the turbine’s combustion gases, is capable of producing about one gallon of water for every gallon of fuel burned, Sherif said. The water would need to be treated to be potable, but even if untreated it could be used for cleaning or other purposes. Because the plant reuses gases so extensively, the power plant also has very low polluting emissions, Lear added. Sherif, Lear and colleagues have built a working prototype of the plant for experiment and testing purposes. Housed in an engineering college laboratory, it appears at first as a maze of tubes and pipes reminiscent of a Dr. Seuss drawing. But a closer inspection reveals a carefully designed “flow pattern” routing gases through and around a small gas turbine, with dozens of electronic and pneumatic monitoring probes. Operators run the test plant from an adjacent control room. Lear said further research is required to make the plant more compact and otherwise enhance its performance. That’s one of the goals of the Army’s Small Business Innovation Research Grant to the Gainesville company, Triad Research. He added that larger versions could be used in fixed locations as part of the normal power grid. For example, utilities could build the plant nearby a grocery store warehouse that required both electricity and cooling.